Prestige 100

Product Description: Powder polymer based, healthy and decorative interior wall covering material.

 

Features:                         

Prestige Series Silk Plaster, which contributes to heat and sound insulation, is anti static, does not hold dust. Besides its easy application, it does not harm human health and environment due to its water-based structure. It is odorless, it can be inhaled.

 

Scope of application:

Silkcoat silk plaster can be applied to thin plaster, gypsum plaster, gypsum board, wooden surfaces and non-alkaline surfaces. It is not applied to glass, brick, metal surfaces, exterior facades and wet surfaces.

 

Technical Data:

Structure: Powder polymer

Consumption: 220-300 (g / m²)

Thinning ratio: Ready to use

Drying Time: 24 hours

Application Thickness: 1 mm

 

Application:

The application surface should be free from all kinds of dust, dirt and oil. A clean, dry and solid surface should be obtained after lightly smoothing the blistered and old painted surfaces. For new plastered surfaces, firstly Silkcoat Primer should be applied. Old painted, dirty, damp surfaces, paint dirt, soot and other residues on the surface should be thoroughly cleaned. Silkcoat Primer is applied after the application of SX 2000. After the primer application is dry, the application of silk plaster can be started. The material in the bag is kneaded thoroughly by pouring into approximately 6 liters of water. Depending on climate and application conditions, some more water can be added if necessary. After the prepared material has waited for at least 20 minutes, it is applied to the surface with a plastic trowel by a plaster technique so that it obtains an average thickness of 1 mm. Tools should be cleaned immediately after application. When applied to places where the deformation is excessive; It is advisable to add a glass of water for each pouch of Silkcoat SX 2000 to the material before it is kneaded. The surface should not be left halfway during application. Application can be done with plastic trowel and spray gun. . For new coated surfaces, at least 28 days must be waited for the application of paint to the surface. Ambient and surface temperature should be between + 5ºC and + 35ºC during application and product drying.

 

 

 

Warning:

Store the product in a tightly closed container.

Do not pour into the sewer.

 

Storage:

In a cool, clean and dry environment, the product can be stored for a minimum of 1 year without opening the door of the cabinet, without exposure to direct sunlight.

 

Package:

Bag.

WhatsApp WhatsApp